March 15, 2003 at 12:00 pm /
#3527
In similar situations, other software allows you to press ‘Escape’.
March 15, 2003 at 12:00 pm /
#21917
Richard,
When executing a third smoothing on a complex model, a boolean subtraction, or other complex operations, it is obvious that 3DC is either going to take a really long time to complete the comand or will likely retun an error message like andquot;result not solid objectandquot;. To keep the modeling experience productive, if a user sees that it is going to hang for a while, it would be nice to give them the option to abort the current operation.
Regards,
Ken
March 17, 2003 at 12:00 pm /
#21918
This is very true!
April 22, 2004 at 9:58 pm /
#21919
I was thinking the same thing.
You must be logged in to reply in this thread.