February 27, 2011 at 2:41 am /
#4442
Hi Richard,
Hah – tonight I thought I would try moving to Crafter – oops… Pipe Engineer spits an Error #6 Overflow when attempting to build pipes…
Regards,
Scott
February 27, 2011 at 1:31 pm /
#25052
I just tried it and it works on my install.
February 27, 2011 at 2:19 pm /
#25053
Hi Dick,
Thanks – maybe I should try a complete removal and fresh install… I’ve been loading new versions over the old ones a whole bunch as Richard releases them…
Regards,
Scott
February 27, 2011 at 4:52 pm /
#25054
I didn’t make any installs until admin said he was done with 8 and moving on to 9.
February 28, 2011 at 10:22 am /
#25055
I think this was a problem, but is fixed in the current release. So, yes it’s possible that something didn’t get updated properly during an install.
You must be logged in to reply in this thread.