Can’t find ‘Pipe Builder’-�

It works like a charm.

Thanks, Bill

Got my sand and steam domes under control and now need to make s curved handrail, but can’t find the ‘Pipe Builder’-� plug in.

Am using Pro 6.6.1.0 with Plugins6610, and also have Pro 6.5.1.0 with Plug6505, but can’t find it in either one. I know I used to have it because I have used it (and loved it).

Have run searches in both Amabilis and Decapods forums but found nothing implying that doesn’t work with these versions.

Thanks again for any help, Bill

You’ll need to go to your options and use the plugin and operations managers to enable them by clicking their check boxes.

Richard

I looked there and didn’t even find it listed, plus all my PlugIns are enabled. Also looked at the individual files in the PlugIn downloads and didn’t see it there either. Sure is frustrating.

Thanks for the input though.

Bill

This is the one I’m using…works with 6.5.1.0.
Hope it helps..

Bazza

Pipe builder should be included with the standard 3DC.

I have produced a new version 2.0 with a couple of extra parameters (see scripts/plugin forum about ‘pipe builder localisation problem’ – version for 6.5.0.5+ is there)

The version for 6.6.1.0 is attached…

Bazza Downloaded PB, from your post, and it shows in 6510. Haven’t had time to try it yet but it should be OK. Thanks a bunch.

Paul Downloaded Pipe7 and put in both 6610 and 6510 (before trying the DL from Bazza) but it doesn’t show up in either one. Checked both Operation Managers and it isn’t listed in either one.

Bill

Here is one that definitely works with 6.6.1.0…