Hi all,
I'm looking for advise on how you would round corners and edges.

This is supposed to be an old adobe jailhouse and I would like to round the edges and corners.



How would you do it?

Thank you in advance,

WOW! 40 views and no help.

I found the chamfer tool but was wondering if there is a more rounding effect tool.
I didn't know and was the reason why I was asking, "How would you do it."

I replied on the TRS forum a few hours ago.

For a more rounded effect, chamfer once, then chamfer the 2 new edges with about half the value you used first time.

Was that you? LOL

I was going to try that. I only chamfered once but I understand, now.

Thanks, Paul.

I use the same technique and get great results.

I use this method to create curved (chamfered) "forms" and then use the PIPE tool to follow the edges and make the railings.

Have a look below. All the railings were done with CUBE frames that got multi-pass chamfered edges then followed with pipe tool.

Example: http://www.railsimstuff.com/images/Current.jpg

Very very nice!

I'll look into the pipe tool. Didn't know anything about it.

Why did you start with the CUBE? Why not the tube then reduce faces?

Thanks,