Not sure if this is a bug or not but you can't set the extrusion amount to more than 100, maybe it's always been like that.
Could it be changed to an unlimited amount.

Thanks

Bazza

This message has been edited. Last edited by: Amabilis Support,

Curiously, I notice that limit recently too, only after a retaining wall I was modeling for Train Simulator did not follow the curves and straights of tracks next to it.

So, I thought it was a bug too, but then I went back to an 6.5.1 and found the same limit was in effect.

So I worked around the problem, but I was still curious about why there would be an upper limit of 100.0 units for an extrustion.

I've upped it to 999 for the next release.