Possible bug or a change in behaviour (since 6.6 and 7.0 were released)

The Solidify operation on a pipe created by my plugin used to cover over the ends.
Now it just adds a few triangles across the face and along it's length.

This message has been edited. Last edited by: Amabilis Support,

It works, if you are willing to use the operation a second time on the same open ended tube. Still agree that it's buggy... since Canvas DINGS at me everytime I use the operation.

This is fixed in 7.0.2 which is now available.

I loaded a model previously made in 6.5 into ver 7.0.21. Some triangles were missing in a body section which was already made from the extrude tool in object building tools. I used solidify to fill the missing parts but it made no difference.

Another possible bug I found was that when I minimised the program (7.0.21) and then later attempted to restore, the program crashed with a white screen and "not responding" message.

Bug 3 - I mentioned in the plugins thread. This one can seriously hamper play as I use this type of extrude a lot.

Tony

Can you send me the model that had problems? (support@amabilis.com)

Richard, I've just sent it.