Hello,

I noticed this a long time ago but didn't took time to post.

English decimal separator is . (0.1 for example).
In other places like in France it is , (0,1).

When using pipe builder, neither . or , are working.

Is it possible to fix this pb please so that I can use this great plugin to make small pipes ?

(with MSTS Engineer I can use the 0,1 notation)

This message has been edited. Last edited by: DOM107,

I'm onto the task - it may take a day or two before I get a chance, the new version of SView goes out tomorrow.

Thanks a lot !

No errors reported with SView 1.5 so far, so I have done a new version of pipe builder for
canvas 6.5.0.5+ for you to try.

There are two more prompts...
First is an offset in degrees that determines where around the first point to start - really only affects things when you have 3 or 4 sides.

A height/width ratio - 0.5 will make an oval pipe half the diameter high.

Pipe7.zip (13 Kb, 40 downloads) Pipe Builder 2.0

Excellent ! Very useful new features !

(tested on 6.5.1.0 pro)