September 18, 2001
at 12:00 pm /
#1745
Yes I think so. If you set the curve type to N-Spline and the quality level to 1 the resulting points created will match the control points.
Richard
PS the 3×3 set of faces you mention are actually what is called the andquot;cageandquot;. This is just a convenience to show how control points are related to each other.
September 18, 2001
at 12:00 pm /
#14873
Hello all,
Is there a way to get the mesh points to end up where the control points were in surface modeling?
After surface modeling with units that are 3×3 faces I get 4×4 faces for each unit once I’m back in the Scene view. andnbsp;This is a problem for me since I would like precise control over where mesh points end up so that my object creases in the right places.
I hope I’m making myself clear, and thanks for any help.
Cheers
Clem