flippa October 29, 2001 at 12:00 pm / #1082 load the model in 3DC then right click on the model then slect add to library. just make sure your library is set to where you want the model to go. You must be logged in to reply in this thread. 1 post recent posts Componenet Library Corrupt,Library Corrupt… 10 years ago Componenet Library Corrupt,Library Corrupt… 10 years, 1 month ago Crashing when using operation adjust tool 10 years, 1 month ago Crashing when using operation adjust tool 10 years, 2 months ago Crashing when using operation adjust tool 10 years, 2 months ago Crashing when using operation adjust tool 10 years, 2 months ago Crashing when using operation adjust tool 10 years, 2 months ago 3D Crafter does not work 10 years, 4 months ago 3D Crafter does not work 10 years, 4 months ago 3D Crafter does not work 10 years, 4 months ago