Pivot point in Rail Simulator

Fixed it, it was my own fault, I was viewing the incorrect version of my model, it had updated fine.

Mike

I have built a model of a container stack for use in Rail Simulator, I lowered the pivot point to ground level as with MSTS models. However when the model is exported into the simulator, the container stack is buried about three quarters of its height.

What needs to be done so that the model exports to be at ground level?

Mike.

Hi Big Pete,

The method you suggested is what I had done, but did not help. I had always assumed that if the pivot point was moved to ground level, then that was where the model would stand. However the following are how the model exports to RS.

I am going to move the pivot point down by about 10 feet and see if I can get the model to sit properly, but this seems the completely wrong way of doing this.

Mike