Hi Bill,
I’m not sure what shape you want but I think you can use the following sequence to get what you might want.
First select a cube[img:mph2frny]http://i61.photobucket.com/albums/h41/wmalder/Bell%20Hanger/BellHanger1.jpg[/img:mph2frny]
Select opposite faces, extrude and move down while constraining ‘Y’.[img:mph2frny]http://i61.photobucket.com/albums/h41/wmalder/Bell%20Hanger/BellHanger2.jpg[/img:mph2frny]
Select the lowest edge, constrain ‘Y’ and move the edge up[img:mph2frny]http://i61.photobucket.com/albums/h41/wmalder/Bell%20Hanger/BellHanger3.jpg[/img:mph2frny]
Adjust the edge using ‘X’ and the scale option to maintain symmetry[img:mph2frny]http://i61.photobucket.com/albums/h41/wmalder/Bell%20Hanger/BellHanger3.jpg[/img:mph2frny]
Then extrude the faces[img:mph2frny]http://i61.photobucket.com/albums/h41/wmalder/Bell%20Hanger/BellHanger5.jpg[/img:mph2frny]
Select the lowest points or edge and move them upwards again constraining ‘Y’ until they create two level plains[img:mph2frny]http://i61.photobucket.com/albums/h41/wmalder/Bell%20Hanger/BellHanger6.jpg[/img:mph2frny]
Select them and extrude them[img:mph2frny]http://i61.photobucket.com/albums/h41/wmalder/Bell%20Hanger/BellHanger8.jpg[/img:mph2frny]
Then constraining ‘Y’, lengthen to taste and there is a crude bell hanger as I envision it.[img:mph2frny]http://i61.photobucket.com/albums/h41/wmalder/Bell%20Hanger/BellHanger9.jpg[/img:mph2frny]
I hope that’s of some help.